Fujitsu PRIMERGY BX400 S1 User Manual download pdf (Page 75)

BX400 S1 Operating Manual 75

Installation and operation

Power Contains power management settings

Power settings (1) (Default values are highlighted):

– Consumption mode (No Consumption Control / Enforced

Max. Limit / Low Noise Operation / Minimum Power Cons. /

Scheduled Cons. Mode)

– PSU control enabled

– PSU redundancy (No Redundancy / PSU Redundancy /

Phase Redundancy)

– PSU Dynamic Mode enable (ON / OFF)

Power settings (2):

– Maximum Power Limit (value of "Minimum Power Limit" as

printed in the same menu)

Power settings (3):

– PSU/Phase Assignment (Unassigned)

– Phase Limit (no value)

PIN Contains a four-digit PIN as password protection for the

ServerView Local Service Display for Blade

Default values:

– PIN enabled (OFF)

– PIN (0000)

Check Ekeying Check: This is a function which allows you to query the

compatibility of the modules before startup, and then activate,

partially activate or deactivate the module depending on the

result. For example, you would not activate modules whose

operating voltages or power consumption are not compatible with

the system.

This test begins automatically after switch-on or after a hardware

replacement. If errors are found, you can find out more about

them via the Details button. Replace the defective hardware

component and repeat the test.

Save Clicking the Save button saves and applies the settings in the

management blade.

With the Previous button you can go back and change

parameters. You save the changed configuration with the Save

button.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 135 136

No comments

Fujitsu PRIMERGY BX400 S1 User Manual Page 75