Fujitsu PenCentra 130 Instruction Manual download pdf (Page 31)

Inserting/Removing PC Cards

2-5

Replacing the Pen 2

With use, the pen tip may become worn or may pick up abrasive particles that can

scratch the screen. A damaged or warped tip may not move freely, causing

unpredictable results when using the pen. If your pen exhibits these problems,

replace the pen.

Inserting/Removing PC Cards 2

There are two PC Card slots in your PenCentra 130. With the system display facing

you, slot 1 is located on the left and slot 2 is on the right (see Figure 2-2). To install a

PC Card, insert it into the selected slot with the label facing towards the screen. The

shutter covering the slot folds into the system as you insert the card. Ensure that the

card is properly seated by firmly pushing it in until it stops. When the card is

properly seated, the ejector button rises to be flush with the system surface.

To remove a PC Card, first ensure that it is not running. Using the back end of your

PenCentra pen, press the ejector button for the card you are removing. When the

button is pressed, the PC Card is ejected from the slot. Gently pull the card from the

slot.

Figure 2-2 Inserting/Removing PC Cards

Powering the PenCentra 130 2

The PenCentra 130 can be powered by either its rechargeable battery pack or by AC

power adapter.

PC Card Slot 2

Ejector

Button

Ejector

Button

PC Card

Slot 1

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 115 116

No comments

Fujitsu PenCentra 130 Instruction Manual Page 31