Fujitsu SPARC M3000 User Manual download pdf (Page 51)

C120-E360-06EN 3-9

3.2 setrcic

•OPTIONS

The following options are supported:

•OPERANDS

The following operands are supported:

• EXTENDED DESCRIPTION

z When the setrci(8) command or setrcic(8) command is being executed on another

host in the RCI network, do not execute the setrcic(8) command.

z When the setrcic(8) command is executed, set all RCI units that are connected to

RCI into the power-on state or standby state.

z Executing the setrcic(8) command on a model that does not support the RCI

function causes an error to occur.

-c exrdy

RCI_address

[time]

Sets the EXRDY monitoring timeout period of the specified external

power control devices. Set the EXRDY monitoring timeout period in

units of minutes for time. If 0 is specified, EXRDY monitoring is

disabled. If time is omitted, the EXRDY monitoring timeout period is

displayed.

-c opcalldisp Displays the status of the operator call signals of the specified external

power control devices.

-c opcallon

RCI_address

callNo

Sets the operator call signals of the specified external power control

devices on. Setting is made for the devices corresponding to the bits of

callNo that contain "1".

-c opcalloff

RCI_address

callNo

Sets the operator call signals of the specified external power control

devices off. Setting is made for the devices corresponding to the bits of

callNo that contain "1".

-h Displays usage statement. When used with other options or operands, an

error occurs.

RCI_address Specifies a target RCI address. A value in any of the following ranges

can be specified for RCI_address:

003001ff-00307fff

007001ff-00707fff

time Sets the EXRDY monitoring timeout period when "-c exrdy" is specified

in units of minutes. Any decimal integer number ranging from 0 to 85

can be specified.

callNo Specifies operator call information. A two-digit hexadecimal number

can be specified.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56

Comments to this Manuals

No comments

Fujitsu SPARC M3000 User Manual Page 51

Comments to this Manuals