Fujitsu ST4000 User Manual download pdf (Page 36)

Stylistic ST4000 Series Tablet PC User’s Guide – Section Two

Figure 2-6. Removing a PC Card

REMOVING AND INSTALLING

MEMORY MODULES

There is one DIMM slot in your Tablet PC and 256MB

on the motherboard. 256MB and 512MB modules are

available, so you can install a combination of up to

768MB in the system.

Installing a Memory Module

To install a DIMM module in the Tablet PC:

1. Ensure that the Tablet PC is off. To do so, carry out

the Shut Down command in the Start menu. (Do

not attempt to remove or install a DIMM module

when the system is in Suspend mode or running.)

2. Remove the two screws from the cover plate on the

back of the Tablet PC and remove the cover plate as

shown in Figure 2-7.

Figure 2-7. Accessing the Memory Slot

3. Insert the DIMM module in the socket at an angle

and push it down until it locks into place as shown

in Figure 2-8. Note that the DIMM module is keyed

to prevent it from being inserted backwards.

Figure 2-8. Installing a DIMM Module

4. Reinstall the cover and screws that you removed in

step 2.

5. Confirm that the DIMM module is recognized by

the system. To do so, run BIOS Setup. The size of

the DIMM module should be displayed in the Info

menu in BIOS Setup.

The DIMM module is installed in the Tablet PC and you

can now use the system.

Removing a Memory Module

To remove a DIMM module:

1. Ensure that the Tablet PC is off. To do so, carry out

the Shut Down command in the Start menu. (Do

not attempt to remove or install a DIMM module

when the system is in Suspend mode or running.)

2. Remove the screws from the cover plate on the back

of the Tablet PC and remove the cover plate as

shown in Figure 2-7.

3. Spread the fingers on the socket that lock the DIMM

module in place until the DIMM module is loose.

4. Remove the DIMM module from the socket.

The DIMM module is now removed from the Tablet PC.

Refer to “Installing a Memory Module” on page 26 to

install a new DIMM module.

CAUTION

DIMM replacement should only be performed at a

static-free workstation. Avoid touching connector pins,

circuit boards, or other circuit components on the drive

or Tablet PC. Electrostatic discharge caused by doing so

can damage sensitive components.

Alb_UG_Active B.book Page 26 Monday, October 21, 2002 12:15 PM

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 73 74

Comments to this Manuals

No comments

Fujitsu ST4000 User Manual Page 36

Comments to this Manuals

Related products and manuals for Tablets Fujitsu ST4000