Fujitsu MHV2040BS User Manual download pdf (Page 32)

Removal and Replacement Procedure

2-2 C141-F075

2.1 Spare Parts

See Table 2.1 for the model and parts numbers to order the replacement disk

drive.

Table 2.1 Model and parts numbers

Model Name

Capacity

(user area)

Mounting screw Order No.

MHV2080BS 80GB M3 Depth 3 CA06672-B708

MHV2060BS 60GB M3 Depth 3 CA06672-B706

MHV2040BS 40GB M3 Depth 3 CA06672-B704

2.2 Disk Drive Removal

The method and procedures to demount the disk drive to check the jumper

terminal, change the jumper position, or replace the device differ depend on the

system cabinet structure. Therefore, for actual working procedures, the specific

conditions necessary for each system must be determined. The general removal

procedures, with notes, are as follows.

a) Disconnect the power-interface cable.

b) Remove the screws that attach the drive and remove the drive from the

system cabinet.

c) When storing or transporting the drive, pack it an antistatic bag in

compliance with section 1.1.2 (5) d. and (5) e..

To protect the device from damage and prevent the worker getting hurt, observe

the following cautions and precautions in Subsection 1.1.1.

Damage or Device damage

1. Perform any removal after the system power is completely

disconnected. The cable must not be disconnected and the

screws that attach the drive must not be removed with the

power ON.

2. Do not move the drive and attach or detach the connector until

it comes to a complete stop (about 30 s after the power is

turned OFF).

3. Perform the human body grounding to discharge any static

electricity from your body. (Be sure to wear a wrist strap)

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 41 42

No comments

Fujitsu MHV2040BS User Manual Page 32