Fujitsu PRIMERGY RX600 S5 User Manual download pdf (Page 15)

RX600 S5 Operating Manual 15

Preface Features

System board

The features of the system board are described in the technical manual for the

system board D2870 for the hardware and in the BIOS Setup manual for the

firmware.

Hot-plug PCI slots

The server has ten PCI-Express slots, where two of them are hot-plug slots.

These hot-plug PCI-Express slots allow installation and removal of boards

during operation when the operating system supports this function (for further

details see section "Hot-plug expansion cards" on page 107).

Hard disk drives

The server can be equipped with up to 8 SAS/SATA HDD modules. Each HDD

module can accommodate a SAS/SATA hard disk drive with a 2.5-inch format.

The modules are connected to the SAS/SATA backplane wirelessly. This allows

HDD modules to be plugged in or pulled out easily.

The hard disk system is designed for SAS/SATA with one channel for each hard

disk drive.

If the server has the corresponding RAID configuration, HDD modules can also

be replaced during operation.

SAS/SATA controller card (optionally with RAID controller)

The SAS/SATA controller card for operating up to eight SAS/SATA hard disk

drives can be alternately without or with RAID functionality. In case of RAID

functionality the levels 0, 1, 1E, 5, 6, 10, 50 and 60 are supported.

Battery Backup Units

Up to two intelligent Battery Backup Units (iBBUs) back up the memory contents

of their corresponding RAID controllers in the event of power failure (option).

Accessible drives/components

A number of mounting locations are available:

– An installation slot for a ServerView Local Service Display (standard)

– An installation slot for a slimline CD/DVD/BD drive (standard)

– A 5.25-inch bay for a magnetic tape drive (option)

1 ... 14 15 16 ... 148

No comments

Fujitsu PRIMERGY RX600 S5 User Manual Page 15