Fujitsu MCE3064AP User Manual download pdf (Page 152)

5 - 4 C156-E142-02EN

Figure 5.2 Inserting cartridge

5.1.4 Ejecting (removing) cartridge

Remove the cartridge as explained below.

(1) When the drive power is on:

1) The cartridge can be removed by pressing the eject button.

Notes:

1. If the command prevents ejection, the cartridge cannot be removed.

2. Remove the cartridge when completely ejected.

Note:

Even if the drive set-up conditions are met, note that the cartridge can drop from the drive after

ejection depending on the ambient environment and the cartridge's condition.

(2) When the drive power is off:

If the drive power is off, the cartridge cannot be removed by pressing the eject button. The

cartridge can be removed by insert the eject jig (accessory) or a pin (diameter: about 1 mm) into

the manual eject hole.

Notes

1) NEVER attempt to eject the cartridge while the BUSY LED lamp is on. The data may be

destroyed or trouble may result in the drive.

2) Note that the cartridge may drop from the drive when it is ejected.

Push by hand the width of 20mm to the

right and left from the cartridge rear

center, to the position shown at right.

Shutter

Inserting direction

1 ... 151 152 153 ... 175

No comments

Fujitsu MCE3064AP User Manual Page 152