Fujitsu RX200 User Manual download pdf (Page 29)

RX200 S5 Options Guide 29

Processors Replacing the heat sin

5.3 Replacing the heat sink

Ê Open the server as described in chapter “Preparation” on page 19.

Ê Lift the air cowl upwards to remove it as described in section “Removing the

air cowl” on page 22.

Ê Remove the four screws of the heat sink in a crossover pattern (see figure 9

on page 26).

Ê Loosen the heat sink carefully by turning it back and forth. Then lift it up and

off.

Ê Clean the upper side of the processor using a lint-free cloth.

I New heat sinks come with thermal paste already applied. When reusing

used heat sinks, you need to apply thermal paste.

Ê Place the heat sink on the processor (see figure 8 on page 25).

Ê Fasten the heat sink by tightening the four screws in a crossover pattern (see

figure 8 on page 25).

Ê Fit the air cowl as described in chapter “Completion” on page 61.

Ê Close the server, connect all power plugs to the power outlets, and switch on

the server as described in chapter “Completion” on page 61.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 71 72

No comments

Fujitsu RX200 User Manual Page 29