Fujitsu AOU12CQ User Manual

ASU9CQASU12CQAOU9CQAOU12CQ

En-10ADJUSTING THE DIRECTION OF AIR CIRCULATIONVertical (up-down) direction of airflow is adjusted by pressing the Remote Control Unit’s SET button. H

En-11SWING OPERATIONBegin air conditioner operation before performing this procedure.To select SWING OperationPress the SWING button (Fig. 6 P).The SW

En-12Before cleaning the plasma filter unit, be sure to turn off the power supply to the air conditioner.Electric shock may result.● When used for ext

En-13CLEANING THE PLASMA AIR CLEANING FILTER CAUTION! WARNING!● Make sure the plasma filter unit is properly mounted before cleaning or performing oth

En-145. Install the air filter.● Please consult instructions for cleaning the air filteron page 12.6. Close the intake grille.Push the intake grill i

En-15Air-cleaning and Deodorizing filtermaintenanceAs well as ensuring the maintenance of the dust collectingunit, please also take care of the filter

En-16TROUBLESHOOTINGIn the event of a malfunction (burning smell, etc.), immediately stop operation, disconnect thePower Supply Plug, and consult auth

En-17TROUBLESHOOTINGSymptomDoesn’t operate at all:Poor Cooling or Heatingperformance:The unit operatesdifferently from the RemoteControl Unit’s settin

En-18OPERATING TIPSOutdoor temperatureIndoor temperatureCooling/Dry ModeAbout 32 to 115 °FAbout 64 to 90 °FTemperature and Humidity RangeIf the unit i

En-2Fig. 1 Indoor Unit1 Operating Control Panel (Fig. 2)2 AIR CLEANER RESET / MANUAL AUTObutton●Intake grill opening mechanism.When the remote control

En-3FEATURES AND FUNCTIONSSLEEP TIMERWhen SLEEP is selected be pressing TIMER button duringHeating mode, the air conditioner’s thermostat setting isgr

En-4PREPARATION CAUTION!● Take care to prevent infants fromaccidentally swallowing batteries.● When not using the remote control unitfor an extended

En-5To Select Mode Operation1Press the START / STOP button (Fig.6 M).The indoor unit’s OPERATION indicator lamp (red) (Fig. 3 5) will light.The air co

En-6OPERATIONAbout Mode OperationAUTO: ● Depending on the room temperature at the time operation begins, theoperating mode will be switched automatica

En-7AIR CLEANING OPERATION2Press the AIR CLEAN button (Fig. 6 N).The AIR CLEAN indicator lamp (Fig. 3 7) will light up (green, as shown inthe figure).

En-8TIMER OPERATIONTo Use the ON timer or OFF timer1Press the START / STOP button (Fig. 6 M).(if the unit is already operating, proceed to step 2).The

En-9SLEEP TIMER OPERATIONUnlike other timer functions; the SLEEP timer is used to set the length of time until air conditioner operation is stopped.To