Fujitsu ST6012 User's Guide download pdf (Page 109)

109

Using a UWB Device

The Integrated Certified Wireless USB (UWB) module is an optional device available for Fujitsu mobile

computers.

What is Certified Wireless USB?

Certified Wireless USB, is a short range, high bandwidth RF communication protocol that is capable of

sending 480 Mbps at distances up to 3 meters (approximately 10 feet) and 110 Mbps at up to 10 meters

(approximately 33 feet). UWB is designed to operate in the 3.1 GHz to 10.6 GHz RF band in the United

States.

UWB is not a networking technology; instead it uses the same hub and spoke model used by traditional

wired USB. This architecture is one in which a single host, otherwise known as a hub, manages up to 127

end devices.

Using Certified Wireless USB

Typically, the UWB hub must first be attached to the computer for association before the UWB hub will

be recognized by the UWB module. Please refer to your UWB hub manual for detailed installation

instructions.

The Wireless LAN/UWB/Bluetooth On/Off Switch will power off all of the aforementioned devices

simultaneously. To enable or disable any of the devices individually, perform the following steps:

1 Slide the Wireless LAN/UWB/Bluetooth ON/OFF switch to the ON position (refer to your system User's Guide

if you are unsure of the switch location).

2 In the Control Panel, click the button associated with Bluetooth and/or Wireless LAN Status to enable or disable

the individual devices.

3 Click [OK].

ST6000.book Page 109 Monday, November 3, 2008 10:23 AM

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 131 132

No comments

Fujitsu ST6012 User's Guide Page 109