Fujitsu FI-6140 User Manual download pdf (Page 17)

fi-6140/fi-6240 Image Scanner Getting Started AP-1

Appendix1 TROUBLESHOOTING

■ Troubleshooting checklist

Symptom Check this item Remedy

Scanner does not turn on. Have you pressed the power button on? Push the power button.

Are the AC cable and AC adapter

properly connected to the

scanner?

Correctly connect the AC cable and the AC adapter.

Disconnect the AC cable and the AC adapter from

the scanner, then connect them again.

If this does not restore the power supply, contact

the store where you purchased the scanner or an

authorized FUJITSU scanner service provider.

Is Windows normally started up? Push the power button again after completely

starting up Windows.

Scanning does not start. Are the documents loaded correctly on the

ADF paper chute?

Load the document correctly on ADF paper chute.

Is the ADF closed completely? Close the ADF completely.

Is the USB cable or SCSI cable properly

connected?

Correctly connect the cable. (When a USB hub is

used, check the hub's power supply.)

(When using SCSI interface) Is SCSI ID

set correctly?

Set SCSI ID correctly by SCSI ID switch on rear of

scanner.

Does the Function Number Display

indicates an alarm or an error?

When the Function Number Display indicates an

alarm or an error, refer to chapter 6 "Troubleshoot-

ing" of "fi-6140/fi-6240 Operator’s Guide" for

removing the alarm or the error.

Does the alarm state remain displayed

even after the scanner has been turned off

and back on again?

Turn off and on the power button.

If this does not eliminate the alarm state, contact the

store where you purchased the scanner or an

authorized FUJITSU scanner service provider.

1 2 ... 12 13 14 15 16 17 18 19 20

No comments

Fujitsu FI-6140 User Manual Page 17