Fujitsu RX300 S7 Installation Guide download pdf (Page 84)

84 Operating Manual RX300 S7

Troubleshooting and tips

8.6 Incorrect date and time

Ê Set the date and time in the operating system or in the BIOS Setup under

the Main menu, using System Date and System Time respectively.

I Note that the operating system may affect the system time. For example,

the operating system time may deviate from the system time under

Linux, and would overwrite the system time in the default setting on

shutdown.

If the date and time are still wrong after the server has been switched off and

back on again, replace the lithium battery (for a description refer to the

PRIMERGY RX300 S7 Server Upgrade and Maintenance Manual) or contact

our customer service team.

8.7 System will not boot

The system will not boot after installing a new hard disk drive.

SAS configuration incorrect

Ê Check the settings for the hard disk drives (SAS Device Configuration) and

the additional settings in the SAS configuration menu.

8.8 Drives reported as "dead" when starting

system

This error message may occur when the drives are operated with a RAID

controller.

RAID controller configuration incorrect

Ê Check and correct the settings for the drives using the RAID controller utility.

Further information is provided in the manual for the RAID controller.

1 2 ... 79 80 81 82 83 84 85 86

No comments

Fujitsu RX300 S7 Installation Guide Page 84