Fujitsu RX300 S7 Installation Guide download pdf (Page 85)

RX300 S7 Operating Manual 85

Troubleshooting and tips

8.9 Added drive reported as defective

RAID controller is not configured for this drive

The drive was probably installed when the system was switched off.

Ê Reconfigure the RAID controller for the drive using the corresponding utility.

Information is provided in the documentation for the RAID controller.

Ê Remove and reinstall the drive while the system is switched ON.

If the drive continues to be shown as defective, then replace it.

8.10 Error message on screen

The meaning of the error message is explained in the documentation for the

relevant components and programs on the ServerView Suite DVD 2.

8.11 Expansion cards or onboard devices not

recognized

When an expansion card is added, other expansion cards or onboard devices

might not be recognized.

Ê Reinstall the drivers for the expansion cards or onboard devices that are not

recognized.

8.12 Temperature warning

A temperature warning is output to the hardware event log and OS event log, or

ServerView issues a notification of a temperature warning such as by a popup

message

The above log is output or the above notification is issued by ServerView when

the ambient temperature is within 30 to 35°C, which is near the upper limit of the

temperature boundaries (10 to 35°C). This is to notify the administrator before

the ambient temperature actually exceeds the range of the temperature

boundaries.

1 2 ... 80 81 82 83 84 85 86

No comments

Fujitsu RX300 S7 Installation Guide Page 85