Fujitsu B6220 User Manual download pdf (Page 48)

LifeBook B6200 Series – Section Four

Dead Battery Suspend mode shows on the Status indi-

cator just like the normal Standby mode. Once your

notebook goes into Dead Battery Suspend mode you will

be unable to resume operation until you provide a

source of power either from an adapter, or a charged

battery. Once you have provided power, you will need to

press the Suspend/Resume button to resume operation.

In the Dead Battery Suspend mode, your data can be

maintained for some time, but if a power source is not

provided promptly, the Power indicator will stop

flashing and go out, meaning that you have lost the data

that was not stored. Once you provide power, you can

continue to use your notebook while an adapter is

charging the battery.

Shorted Batteries

The Status Indicator panel uses a symbol inside the

battery outline of the Battery Level indicator to display

the operating level available in that battery.

(See figure 2-11 on page 13) If this display shows a

Shorted Battery, it means that the battery is damaged

and must be replaced so it does not damage any other

parts of your notebook.

REPLACING THE BATTERY

Your LifeBook B6200 Series notebook comes with one

battery pack, but it’s a good idea to purchase a second

one. By keeping a spare battery fully charged, you can

immediately swap with one that is not charged. The

battery can only be replaced by cold-swapping; doing

otherwise could result in loss of data. (Cold swapping

means swapping batteries when the system has been

powered down.)

Cold-swapping Batteries

To cold-swap batteries in your battery bay follow these

easy steps: (Figure 4-1)

1. Have a charged battery ready to install.

2. Shut down your notebook and disconnect the AC

adapter.

Figure 4-1. Removing the Battery

3. Push the battery bay release latches inward, then lift

the front of the battery away from the battery bay

and remove it from the bay.

4. Position the new battery in the bay and carefully lay

it into the tray. (Figure 4-2) Press it down so that the

latches click into place to secure the battery.

5. Turn the power on.

Figure 4-2. Installing the Battery

Battery Bay Release Latches

Battery

If the Lithium ion battery connector is not

fully seated, you may not be able to use

your notebook or charge your battery.

B Series.book Page 40 Thursday, May 17, 2007 2:25 PM

1 ... 47 48 49 ... 128

Comments to this Manuals

No comments

Fujitsu B6220 User Manual Page 48

Comments to this Manuals

Related products and manuals for Laptops Fujitsu B6220