Fujitsu T1000 User Manual download pdf (Page 47)

Chapter 2 Installing the Server 21

Note – When you attach cables to the server, as in the following procedures, lay the

cables over the cable management bracket, then use cable ties to hold each cable in

place.

Removing the Server From the Rack for

Service

To install or replace internal parts in the server, you must first remove the server

from the rack.

For the removal procedure, refer to the SPARC Enterprise T1000 Server Service

Manual.

Connecting the Server Cables

To boot the server, you must connect and configure the network and serial ports. The

procedures are given in the following sections.

■ “To Connect the SC Serial Management Port” on page 22

■ “To Connect the SC Network Management Port” on page 22

■ “To Connect the Ethernet Network Cables” on page 23

■ “To Connect the AC Power Cable to the Server” on page 23

FIGURE 2-9 shows the connectors on the rear panel of the server.

FIGURE 2-9 Rear Panel Connectors

SC network management port

SC serial management port

NET3

NET2

NET1

NET0

TTYA serial port

AC in

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 83 84

No comments

Fujitsu T1000 User Manual Page 47