Fujitsu S6510 User Manual download pdf (Page 42)

- Flexible Bay Devices

Removing and Installing Modular Devices

There are two ways to remove and install modular devices in the Flexible Bay:

• Cold-swapping: swapping devices while your LifeBook notebook is powered off.

• Hot-swapping: swapping devices while your system is active, using the Safely Remove Hardware

icon from your system tray.

Cold-swapping

To cold-swap modular devices in your Flexible Bay follow these easy steps:

YOU SHOULD NEVER LEAVE YOUR FLEXIBLE BAY EMPTY WHEN THE NOTEBOOK IS IN OPERATION. IF LEFT

EMPTY, DUST OR FOREIGN MATTER MAY ACCUMULATE INSIDE THE NOTEBOOK.

1 Close any open files.

2 Shut down your LifeBook notebook.

3 Turn your system upside down.

4 As you press the Flexible Bay release

latch as shown in Figure

18, pull out the

Flexible Bay module until it is clear of

the bay. This will require light force.

5 Slide the device you are installing into

your notebook until it clicks into place.

6 It is now safe to turn your notebook

back on.

7 You can now access and use the

device.

Figure 18. Removing/installing a Flexible Bay device

Flexible Bay

Release Latch

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 202 203

No comments

Fujitsu S6510 User Manual Page 42