Fujitsu S6510 User Manual download pdf (Page 87)

- Memory Upgrade Module

Memory Upgrade Module

Your Fujitsu LifeBook notebook comes with a minimum of 512 MB of high speed Double Data Rate

Synchronous Dynamic RAM (DDR2-667 SDRAM) factory installed. To increase your notebook’s memory

capacity, you may install an additional memory upgrade module. The memory upgrade must be a dual-in-

line (DIMM) SDRAM module. To ensure 100% compatibility, purchase the SDRAM module only from

the Fujitsu web store at www.shopfujitsu.com.

Installing Memory Upgrade Modules

1 Turn off power to your notebook, remove any power adapter (AC or auto/airline). Remove the battery.

2 Make sure that all the connector covers are closed.

3 Turn the notebook bottom side up, and remove the screw from the memory upgrade module compartment.

4 Remove the cover.

5 Remove the memory upgrade module from the static guarded sleeve.

• DO NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE

ONES SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY

UPGRADE MODULE.

• THE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE

(ESD). T

O MINIMIZE RISK TO THE MODULE, OBSERVE THE FOLLOWING PRECAUTIONS:

-- B

EFORE HANDLING A MEMORY MODULE, TOUCH A GROUNDED METAL OBJECT TO DISCHARGE STATIC

ELECTRICITY BUILT UP IN YOUR BODY.

-- W

HEN INSTALLING OR REMOVING A MEMORY MODULE, HOLD IT BY THE EDGE SO AS NOT TO TOUCH

ANY CONTACTS OR CHIPS. BE CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER TERMINALS OR

COMPONENTS; THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS.

-- B

E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES. EVEN

IF THE SYSTEM IS IN HIBERNATE OR STANDBY STATES, DATA COULD BE LOST OR THE MEMORY

COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 202 203

No comments

Fujitsu S6510 User Manual Page 87