Fujitsu fi-5000N User Manual download pdf (Page 11)

fi-5000N Getting Started 3

Chapter 2 INSTALLING THE fi-5000N

The scanning test written in section "2.7 Scan Test", is

explained using the FUJITSU TWAIN 32 scanner driver

and the ScandAll 21 scanning application. In order to

perform this scanning test, follow the instructions in sec-

tion "2.4 Installing the Driver", and install the FUJITSU

TWAIN 32 scanner driver and the ScandAll 21 scanning

application.

2.1 Installing the Scanner

Install the scanner following the installation require-

ments described in your fi-series scanner manual.

2.2 Installing the fi-5000N

1. Place the fi-5000N at its installation site.

Install this product near the scanner. Install it in a

place that does not affect the operation or

maintenance of the scanner. Refer to "fi-5000N

Operator's Guide" for details on the specifications of

this product.

2. Connect the AC adapter.

1. Connect the AC cable to the AC adapter.

2) Connect the AC adapter connector to the fi-

5000N’s DC inlet.

3) Plug the AC cable into the outlet.

3. Connect the USB cable to the USB connector.

4. Connect the other end of the USB interface

cable to the scanner.

ATTENTION

Use only the AC adapter and AC

cable provided by the manufacturer.

ATTENTION

Be sure to use the USB cable pro-

vided with the scanner.

Correct operation with commercially

available cables is not guaranteed.

ATTENTION

The message "Scanner is discon-

nected" is displayed on the Message

Display of fi-5000N if the scanner is

not connected properly, or if the

power of the scanner is turned off.

Check the connection of the scanner

when it happens. Refer to the scanner

product manual for details on turning

on the power of the scanner.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Comments to this Manuals

No comments

Fujitsu fi-5000N User Manual Page 11

Comments to this Manuals

Related products and manuals for Hardware Fujitsu fi-5000N