Fujitsu MBA3073NP User Manual download pdf (Page 94)

5. The saved value of the MODE SELECT parameter is assumed as the

initial value of each parameter after the power-on, the RESET condition,

or the BUS DEVICE RESET message. The initiator can change the

parameter value temporary (actively) at any timing by issuing the

MODE SELECT or MODE SELECT EXTENDED command with

specifying "0" to the SP bit in the CDB.

(1) Error recovery parameter

The following parameters are used to control operations such as HDD internal error recovery:

a. Read/write error recovery parameters (page code = 1)

Parameter Default value

• AWRE:

• ARRE:

• TB:

• EER:

• PER:

• DCR:

Automatic alternate block allocation at Write

operation

Automatic alternate block allocation at read

operation

Uncorrectable data transfer to the initiator

Immediate correction of correctable error

Report of recovered error

Suppression of ECC error correction

1 (enabled)

0 (disabled)

0 (Correction is

enabled.)

• RETRY COUNT AT READ OPERATION

• RETRY COUNT AT WRITE OPERATION

• RECOVERY TIME LIMIT

30 sec

b. Verify error recovery parameters (page code = 7)

Parameter Default value

• ERR:

• PER:

• DTE:

• DCR:

Immediate correction of recoverable error

Report of recovered error

Stop of command processing at successful

error recovery

Suppression of ECC error correction

1 (enabled)

0 (disabled)

0 (Processing is

continued.)

0 (Correction is

enabled.)

• RETRY COUNT AT VERIFICATION 63

c. Additional error recovery parameters (page code = 21)

Parameter Default value

• Retry count at seek error 15

90 C141-E270

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 137 138

Comments to this Manuals

No comments

Fujitsu MBA3073NP User Manual Page 94

Comments to this Manuals

Related products and manuals for Hardware Fujitsu MBA3073NP