Fujitsu S6510 User Manual download pdf (Page 112)

107

- Troubleshooting

*Failure Fixed Disk n (where x=1-4)

The fixed disk is not working or not configured properly. This may mean that the hard drive type

identified in your setup utility does not agree with the type detected by the Power On Self Test. Run

the setup utility to check for the hard drive type settings and correct them if necessary. If the settings

are OK and the message appears when you restart the system, there may be a serious fault which might

cause you to lose data if you continue. Contact your support representative.

*Incorrect Drive A type – run SETUP

Type of floppy drive A: not correctly identified in Setup. This means that the floppy disk drive type

identified in your setup utility does not agree with the type detected by the Power On Self Test. Run

the BIOS setup utility to correct the inconsistency.

*Incorrect Drive B type – run SETUP

Type of floppy drive B: not correctly identified in Setup. This means that the floppy disk drive type

identified in your setup utility does not agree with the type detected by the Power On Self Test. Run

the setup utility to correct the inconsistency.

*Invalid NVRAM Data

Problem with NVRAM access. In the unlikely case that you see this message you may have some

display problems. You can continue operating but should contact your support representative for more

information.

*Keyboard controller error

The keyboard controller test failed. You may have to replace your keyboard or keyboard controller but

may be able to use an external keyboard until then. Contact your support representative.

*Keyboard error

Keyboard not working. You may have to replace your keyboard or keyboard controller but may be able

to use an external keyboard until then. Contact your support representative.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 202 203

No comments

Fujitsu S6510 User Manual Page 112