Fujitsu Network Scanner fi-6010N User Manual download pdf (Page 7)

1.5 Names and Functions of

Parts

This section describes the scanner parts and their func-

tions.

■ Front

■ Rear

■ Removable Parts

Parts that can be removed from the scanner are dis-

played below.

ADF paper chute

Side guides

Top cover

Startup button

[SCAN] button

LCD touch panel

Output tray

Keyboard

Inside the back cover

LAN connector

AC adaptor connector



DF release button

Security cable slot



Back cover

ATTENTION

To remove the back cover of the

scanner, press the tabs on the cover

to unlock it, and pull out. Make sure

to pull the cover out straight, to pre-

vent the it from being damaged.

Pad assembly

Pick roller

Sheet guide

Back cover

Separate shaft

and roller

ADF paper chute

Press the tabs on the

right and left of the cover

and pull out.

fi-6010N Network Scanner Getting Started

Chapter 2 Setting up the Scanner

2.1 Space Requirements

The following space is required to set up the scanner:

Depth: 700mm (28in)

Width: 400mm (16in)

Height: 500mm (20in)

2.2 Installing the Scanner

1. Place the scanner at its installation site.

2. Attach the ADF paper chute.

Hold the ADF paper chute and insert its tabs into

the corresponding slots in the scanner as shown in

the following figure.

The side guides of the ADF paper chute should

face up.

2.3 Connecting the Cables

1. Connect the AC cable to the AC adapter.

2. Connect the AC adapter connector to the scan-

ner's DC inlet.

3. Connect the LAN cable to the LAN connector.

4. Attach the back cover.

Attach the cover with the connected AC cable

and LAN cable protruding out of the lower part

of the cover.

5. Connect the other end of the LAN cable to the

network hub.

6. Insert the AC cable into a power outlet.

⇒ The power is connected but the scanner is not

yet ready for operation.

When lifting the scanner, always

hold it by the indentations on the

bottom of each side to ensure a

stable grip.

Holding the scanner in any other

way may cause it to be dropped

or damaged.

ATTENTION

Use only the AC adapter provided by

the manufacturer.

Tab

To make sure the cover is properly attached,

insert the right and left tabs at the same time.

Tab

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Comments to this Manuals

No comments

Fujitsu Network Scanner fi-6010N User Manual Page 7

Comments to this Manuals

Related products and manuals for Scanners Fujitsu Network Scanner fi-6010N