Fujitsu Network Scanner fi-6010N User Manual download pdf (Page 8)

2.4 Attaching the Keyboard

Cover

The layout of the keyboard may differ according to the

language selected for the operating environment. The

layout of each keyboard cover is prepared according to

language requirements. Take the keyboard cover for the

selected language out of its packaging, and attach it to

the scanner. This scanner is set up for use with an

English (US) keyboard. Therefore, if the scanner is to be

used with an English (US) keyboard attaching a key-

board cover is not required.

1. Clean the surface of the keyboard.

2. Turn the keyboard cover over and remove the

paper backing from the top strip of double-

sided tape.

3. Align the top edge of the keyboard cover with

the protruding guides, and firmly smooth the

double-sided tape down.

Align and attach the top-left corner first, then the

center, and last the top-right corner.

4. Flip up the keyboard cover and remove the

paper backing from the bottom strip of double-

sided tape.

5. Gently stretch the keyboard cover forward and

smooth the double-sided tape down.

Continue setting up the network.

ATTENTION

Check that the power is turned off

before attaching the keyboard cover.

Pay particular attention

to these areas

Underside

Paper backing tape

Top-left guide

Top-center guide

Top-right guide

Top

attachment

area

Flip up the

keyboard cover

Paper

backing tape

Bottom

attachment area

fi-6010N Network Scanner Getting Started

Chapter 3 Setting up for Network Use

3.1 Logging in

To set up the network connection, you must login as the

administrator. The user name and initial password for

the administrator are as follows:

• User Name: admin

• Password: password

1. Press the startup button.

⇒ After the system starts up, the "Language /

Keyboard Selection" screen appears.

2. Select a language.

Select the desired language for the operating envi-

ronment. The default language is "English (US

Keyboard)".

3. Press the [OK] button.

⇒ The "Login" screen appears.

4. Enter the user name.

User name is case sensitive. Enter "admin" here.

Do not move or shake the

scanner when it is turned on.

This can damage the rotating

hard disk drive and cause data to

be lost.

ATTENTION

After turning the power off, wait for at

least ten seconds before turning the

power back on again.

HINT

If touch panel responses seem out of

alignment with the positions of

objects on the LCD screen, calibrate

the screen.

For details, refer to "Appendix A Cali-

brating the Touch Panel" (page 18).

Startup button

HINT

You can select whether or not to display

this screen again at the next start up. To

display the screen again, for "Show this

message at next start up?", press the

[Yes] button. To not display this screen at

next start up, press the [No] button.

To change the setting back to displaying

this screen at the next start up, login as

the administrator and for "Show the

"Language/Keyboard Selection" screen

at next start up?", press the [Yes] button

on the "Language/Keyboard Selection"

screen.

ATTENTION

If the language is changed in Step 2,

the following screen appears.

The message is displayed in the

selected language.

Pressing the [OK] button restarts the

scanner, and the "Login" screen.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

Comments to this Manuals

No comments

Fujitsu Network Scanner fi-6010N User Manual Page 8

Comments to this Manuals

Related products and manuals for Scanners Fujitsu Network Scanner fi-6010N