Fujitsu MCM3064AP User Manual download pdf (Page 55)

3.2 Mounting Requirements

C156-E227-01EN 3-11

3.2.4 Precautions on mounting

(1) Mounting frame structure and clearance

a) For vibration resistance and heat dissipation, mount this optical disk drive

using a frame having an embossed structure shown in Figure 3.6 or a similar

structure providing an equivalent function.

b) A mounting screw must have an inward projection (entry depth) of 3 mm or

less from the outer surface of the mounting frame of the optical disk drive as

shown in Figure 3.6.

c) The upward-downward and left-right clearance between the external surface

of the mounting frame of the optical disk drive and the user's emboss-

structure frame must be at least 1.5 mm.

d) The floating clearance of the optical disk drive must be 1.5 mm or more.

e) When mounting the optical disk drive, the screw tightening torque must be 0.4

to 0.45Nm (4 to 4.6kgf-cm).

f) When the optical disk drive (with a panel) is mounted in a cabinet, there

should be no distortion or deformation in the target housing or the mounting

fittings. Furthermore, the optical disk drive's panel must not be deformed.

If the drive is used with the panel deformed, ejection of the cartridge will be

faulty.

Make sure that the door closes from any position after mounting the optical

disk drive.

Figure 3.6 Mounting frame structure

φ15

or less

φ15

or less

Mounted on the side

Mounted on the bottom

1.5 or

Optical disk drive

3orless

(Unit: mm)

1.5 or

Optical disk drive

3or

less

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 201 202

No comments

Fujitsu MCM3064AP User Manual Page 55