Fujitsu MHW2040AC User Manual download pdf (Page 242)

Operations

6.1 Device Response to the Reset

This section describes how the PDIAG- and DASP- signals responds when the

power of the IDD is turned on or the IDD receives a reset or diagnostic command.

6.1.1 Response to power-on

After the master device (device 0) releases its own power-on reset state, the master

device shall check a DASP- signal for least 500 ms to confirm presence of a slave

device (device 1). The master device recognizes presence of the slave device

when it confirms assertion of the DASP- signal. Then, the master device checks a

PDIAG- signal to see if the slave device has successfully completed the power-on

diagnostics.

If the master device cannot confirm assertion of the DASP- signal within 500 ms,

the master device recognizes that no slave device is connected.

After the slave device (device 1) releases its own power-on reset state, the slave

device shall report its presence and the result of power-on diagnostics to the

master device as described below:

DASP- signal: Asserted within 450 ms.

PDIAG- signal: Negated within 1 ms and asserted within 30 seconds.

The asserted PDIAG-signal is negated 30 seconds after it is asserted if the

command is not received.

6-2 C141-E258

1 2 ... 237 238 239 240 241 242 243 244 245 246 247 ... 277 278

No comments

Fujitsu MHW2040AC User Manual Page 242