Fujitsu LifeBook E8110 User Manual download pdf (Page 54)

LifeBook E8000 Notebook

Memory Upgrade Module

Your Fujitsu LifeBook notebook comes with a minimum

of 256 MB of high speed Double Data Rate Synchronous

Dynamic RAM (DDR2-667 SDRAM) factory installed. To

increase your notebook’s memory capacity, you may

install an additional memory upgrade module. The

memory upgrade must be a dual-in-line (DIMM)

SDRAM module. To ensure 100% compatibility,

purchase the SDRAM module only from the Fujitsu web

store at www.shopfujitsu.com

INSTALLING MEMORY UPGRADE MODULES

1. Turn off power to your notebook, remove any power

adapter (AC or auto/airline). Remove the battery.

2. Make sure that all the connector covers are closed.

3. Turn the notebook bottom side up, and remove the

screws from the memory upgrade module compart-

ment. (Figure 4-9)

4. Remove the cover.

Figure 4-9. Opening the Memory Upgrade Compartment

5. Remove the memory upgrade module from the

static guarded sleeve.

6. Align the memory upgrade module with the part

side up. Align the connector edge of the memory

upgrade module with the connector slot in the

compartment.

7. Insert the memory upgrade module at a 45° angle.

Press the connector edge of the module firmly down

and into the connector until it lodges under the

retaining clip. You will hear a click when it is prop-

erly in place. (Figure 4-10)

Figure 4-10. Installing a Second Memory Module

8. Replace the cover and reinstall the screws.

REMOVING A MEMORY UPGRADE MODULE

1. Perform steps 1 through 4 of Installing a Memory

Upgrade Module.

2. Pull the clips sideways away from each side of the

memory upgrade module at the same time.

3. While holding the clips out, remove the module

from the slot by lifting it up and pulling towards the

rear of your notebook. (Figure 4-11)

■

Do not remove any screws from the

memory upgrade module compartment

except the ones specifically shown in the

directions for installing and removing the

memory upgrade module.

■

The memory upgrade module can be

severely damaged by electrostatic dis-

charge (ESD). To minimize risk to the

module, observe the following precau-

tions:

■

Before handling a memory module,

touch a grounded metal object to

discharge static electricity built up in

your body.

■

When installing or removing a

memory module, hold it by the edge

so as not to touch any contacts or

chips. Be careful not to touch any

internal computer terminals or

components; the oil from your

fingers could cause a short to the

components.

■

Be sure to power down your system

before adding or removing memory

modules. Even if the system is in

hibernate or standby states, data

could be lost or the memory could be

damaged if power is still available to

the system.

The memory upgrade module is not

something you routinely remove from

your notebook. Once it is installed, you

can leave it in place unless you want to

change system memory capacity.

E8110.book Page 44 Tuesday, February 28, 2006 2:59 PM

1 ... 53 54 55 ... 128

Comments to this Manuals

No comments

Fujitsu LifeBook E8110 User Manual Page 54

Comments to this Manuals

Related products and manuals for Laptops Fujitsu LifeBook E8110