Fujitsu LifeBook E8110 User Manual download pdf (Page 68)

LifeBook E8000 Notebook

The LifeBook notebook

turned on with a series of

beeps and your built-in

display is blank.

Power On Self Test (POST)

has detected a failure which

does not allow the display

to operate.

Contact your support representative.

The display goes blank by

itself after you have been

using it.

The notebook has gone into

Video timeout, Standby mode,

Suspend mode or Save-to-Disk

mode because you have not

used it for a period of time.

Press any button on the keyboard, or move the

mouse to restore operation. If that fails, push the

Power/Suspend/Resume button. Check your power

management settings, or close your applications

and go to the Power Savings menu of the setup

utility to adjust the timeout values to better suit

your operation needs. (See BIOS Setup Utility on

page 29 for more information)

The power management time-

outs may be set for very short

intervals and you failed to

notice the display come on

and go off again.

Press any button on the keyboard, or move the mouse

to restore operation. If that fails, push the Power/

Suspend/Resume button. (The display may be shut

off by Standby Mode, Auto Suspend or Video

Timeout)

Something is pushing on the

Closed Cover switch.

Check the Closed Cover switch. (See figure 2-3 on

page 6 for location)

Your system display won’t

turn on when the system is

turned on or when the

system has resumed.

The system may be password-

protected.

Check the status indicator panel to verify that the

Security icon is blinking. If it is blinking, enter your

password.

The Built-in Display does

not close.

A foreign object, such as a

paper clip, is stuck between the

display and the keyboard.

Remove all foreign objects from the keyboard.

The Built-in Display has

bright or dark spots.

If the spots are very tiny and

few in number, this is normal

for a large LCD display.

This is normal; do nothing.

If the spots are numerous or

large enough to interfere with

your operation needs.

Display is faulty; contact your support representative.

The application display

uses only a portion of your

screen and is surrounded

by a dark frame.

You are running an application

that does not support 800 x

600/1024 x 768 pixel resolution

display and display compres-

sion is enabled.

Display compression gives a clearer but smaller

display for applications that do not support 800 x

600/1024 x 768 pixel resolution. You can fill the

screen but have less resolution by changing display

compression settings, (See Video Features submenu

located within the Advanced menu of the BIOS. (See

BIOS Setup Utility on page 29 for more information)

The Display is dark when

on battery power.

The Power Management utility

default is set on low brightness

to conserve power.

Press [Fn] + [F7] to increase brightness or double-

click on the battery gauge and adjust Power Control

under battery settings.

You have connected an

external monitor and it

does not display any

information.

Your BIOS setup is not set to

enable your external monitor.

Toggle the video destination by pressing [Fn]+ [F10]

together, or check your BIOS setup and enable your

external monitor. (See the Video Features submenu,

located within the Advanced Menu of the BIOS. (See

BIOS Setup Utility on page 29 for more information)

Problem Possible Cause Possible Solutions

E8110.book Page 58 Tuesday, February 28, 2006 2:59 PM

1 ... 67 68 69 ... 128

Comments to this Manuals

No comments

Fujitsu LifeBook E8110 User Manual Page 68

Comments to this Manuals

Related products and manuals for Laptops Fujitsu LifeBook E8110