Fujitsu LifeBook E8110 User Manual download pdf (Page 67)

Troubleshooting

The system powers up, and

displays power on informa-

tion, but fails to load the

operating system.

The boot sequence settings

of the setup utility are not

compatible with your

configuration.

Set the operating source by pressing the [ESC] key

while the Fujitsu logo is on screen or use the [F2]

key and enter the setup utility and adjust the source

settings from the Boot menu. (See BIOS Setup

Utility on page 29 for more information)

You have a secured system

requiring a password to load

your operating system.

Make sure you have the right password. Enter the

setup utility and verify the Security settings and

modify them as accordingly. (See BIOS Setup Utility

on page 29 for more information)

Internal hard drive was

not detected.

Use the BIOS setup utility or Primary Master

submenu, located within the Main menu, to try to

auto detect the internal hard drive.

An error message is

displayed on the screen

during the notebook

(boot) sequence.

Power On Self Test (POST) has

detected a problem.

See the Power On Self Test (POST) messages to

determine the meaning and severity of the problem.

Not all messages are errors; some are simply status

indicators. (See Power On Self Test Messages on

page 60 for more information)

Your notebook appears to

change setup parameters

when you start it.

BIOS setup changes were not

saved when you made them

and exited the setup utility

returning it to earlier settings.

Make sure you select Save Changes And Exit when

exiting the BIOS setup utility.

The BIOS CMOS hold-up

battery has failed.

Contact your support representative for repairs.

This is not a user serviceable part but has a normal

life of 3 to 5 years.

Your system display won’t

turn on when the system is

turned on or has resumed.

You have installed the Life-

Book/Security Application

panel.

Check the Status Indicator Panel for presence of the

Security icon. If it is visible, enter your password

((See Security Indicator on page 13 for more informa-

tion)

Video Problems

The built-in display is

blank when you turn on

your LifeBook notebook.

Something is pushing on the

Closed Cover switch.

Clear the Closed Cover switch. (See figure 2-3 on

page 6 for location)

The notebook is set for an

external monitor only.

Pressing [F10] while holding down the [Fn] key

allows you to change your selection of where to send

your display video. Each time you press the keys you

will step to the next choice. The choices, in order

are: built-in display only, external monitor only,

both built-in display and external monitor.

The display angle and bright-

ness settings are not adequate

for your lighting conditions.

Move the display and the brightness control until

you have adequate visibility. Pressing either the [F6]

or [F7] keys while holding down the [Fn] key also

allows you to change the brightness level of the

display.

The power management time-

outs may be set for very short

intervals and you failed to

notice the display come on

and go off again.

Press a keyboard button or move the mouse to

restore operation. If that fails, push the Power/

Suspend/Resume button. (The display may be shut

off by Standby mode, Auto Suspend or Video

Timeout)

Problem Possible Cause Possible Solutions

E8110.book Page 57 Tuesday, February 28, 2006 2:59 PM

1 ... 66 67 68 ... 128

Comments to this Manuals

No comments

Fujitsu LifeBook E8110 User Manual Page 67

Comments to this Manuals

Related products and manuals for Laptops Fujitsu LifeBook E8110