Fujitsu S300M User Manual download pdf (Page 195)

8.2 Cleaning the Inside of the ScanSnap

ScanSnap S300M Operator's Guide 175

Daily Care

8.2 Cleaning the Inside of the ScanSnap

Clean the inside of the ScanSnap with a cloth moistened with Cleaner F1.

After the ScanSnap has been in use for a period of time, its inside will be contaminated with paper

debris and dust. The accumulation of debris and dust may cause scanning problems.

As a guideline, clean the ADF at least every 200 scans. Note that this depends on the type of the

documents scanned. For example, the ADF must be cleaned more frequently if documents are

scanned when the ink has not been sufficiently fixed on the paper.

Clean the ADF according to the following procedure. (Refer to the illustrations on the following

page.)

1. Pull the cover open lever to open the ADF.

ATTENTION

• Do not use water or neutral detergent to clean the inside of the ScanSnap.

• Do not use compressed air to clean the ScanSnap. Compressed air cause dirt

and dust to enter the ScanSnap, which may result in ScanSnap failure and

malfunction, or errors in scanned images.

• It may take long before the cleaner vaporizes if a large quantity is used. When

cleaning the ScanSnap parts, dampen a cloth with modest quantities of the

cleaner. In addition, wipe off the cleaner completely with a soft lint-free cloth to

leave no residue on the surface of the cleaned parts.

ADF

Cover open lever

Paper

chute

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 226 227

No comments

Fujitsu S300M User Manual Page 195