Fujitsu Lifebook T731 User Manual download pdf (Page 92)

- Memory Upgrade Module

Memory Upgrade Module

Your Fujitsu LIFEBOOK Tablet PC comes with a minimum of 1 GB of high speed Double Data Rate

Synchronous Dynamic RAM (DDR3-1333 SDRAM) factory installed. To increase your Tablet PC’s

memory capacity, you may install an additional memory upgrade module. The memory upgrade must be a

dual-in-line (DIMM) SDRAM module. To ensure 100% compatibility, purchase the SDRAM module only

from the Fujitsu web store at www.shopfujitsu.com.

Installing Memory Upgrade Modules

1 Turn off power to your Tablet PC, remove any power adapter (AC or auto/airline). Remove the battery.

2 Make sure that all the connector covers are closed.

3 Turn the Tablet PC bottom side up, and remove the screws from the memory upgrade module compartment.

4 Slide the cover towards the battery compartment slightly, then lift it and remove it (Figure 38).

5 Remove the memory upgrade module from the static guarded sleeve.

6 Align the memory upgrade module with the part side up. Align the connector edge of the memory upgrade

module with the connector slot in the compartment.(Figure 39)

• DO NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE

ONES SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY

UPGRADE MODULE.

• THE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE

(ESD). T

O MINIMIZE RISK TO THE MODULE, OBSERVE THE FOLLOWING PRECAUTIONS:

• BEFORE HANDLING A MEMORY MODULE, TOUCH A GROUNDED METAL OBJECT TO DISCHARGE

STATIC ELECTRICITY BUILT UP IN YOUR BODY.

• WHEN INSTALLING OR REMOVING A MEMORY MODULE, HOLD IT BY THE EDGE SO AS NOT TO

TOUCH ANY CONTACTS OR CHIPS. BE CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER

TERMINALS OR COMPONENTS; THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE

COMPONENTS.

• BE SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES.

VEN IF THE SYSTEM IS IN HIBERNATE OR SLEEP STATES, DATA COULD BE LOST OR THE MEMORY

COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM.

Claw T731 UG.book Page 91 Wednesday, May 25, 2011 3:50 PM

1 ... 91 92 93 ... 418

No comments

Fujitsu Lifebook T731 User Manual Page 92