Getting s tarted
Getting started
Gettingstarted
Please observe the safet y information in the "Impo rtant notes", Page 3 chapter.
Unpacking and checking the delivery
It is recommended not to throw away the original packaging material! It may be
required for reshipment at some later date.
PackagingContentsofd eliveryPackaging,
► U npack all the individual parts.
► C heck the contents of the package f
or any visible damage caused during transport.
► C heck whether the delivery conforms to the details in the delivery note.
► If the delivery does not correspo
nd to the delivery note or if any part of the de livery
is dama ged, please notify your lo
cal sales outlet immediately.
Steps for initial setup
Preparingforfi rstuse, overviewPreparingforu se,
Only a few steps are necessary to put your new device into operation for the first time:
• Select a location for device and set up device
• Connecting external devices
• Check the voltage at the mains outlet and connect the device to an electrical outlet
• Switch the device on
You will learn more about the individual steps in the following sections.
External devices
If you have received other e xternal devices in addition to your own de vice (e.g.
a printer), do not co nnect the se until after the initial installation. The following
sections describe how to connect these external devices.
Drives and boards
If you have received drives or boards with your device, please do not install
them until after first-time setup. How to install drives and bo ards is described
in the "
System expansions", Page 27 chapter.
6 A26361-K1002-Z220-1-7619, editio n 2
Comments to this Manuals