Fujitsu C1410 User Manual download pdf (Page 44)

LifeBook C1400 Series Notebook - Section Four

Dead Battery Suspend mode shows on the Status indi-

cator just like the normal Suspend mode. Once your

notebook goes into Dead Battery Suspend mode you will

be unable to resume operation until you provide a

source of power either from an adapter, or a charged

battery. Once you have provided power, you will need to

press the Power/Suspend/Resume button to resume

operation.

In the Dead Battery Suspend mode, your data can be

maintained for some time, but if a power source is not

provided promptly, the Power indicator will stop

flashing and go out, meaning that you have lost the data

that was not stored. Once you provide power, you can

continue to use your notebook while an adapter is

charging the battery.

Shorted Batteries

The Status Indicator panel uses a symbol inside the

battery outline of the Battery Level indicator to display

the operating level available in that battery. (See figure 2-

9 on page 11) If this display shows a Shorted Battery, it

means the battery is damaged and must be replaced so it

does not damage other parts of your LifeBook notebook.

REPLACING THE BATTERY

With the purchase of an additional battery, you can have

a fully charged spare to swap with one that is not

charged. There are two ways to swap batteries, cold-

swapping and hot-swapping:

Cold-swapping Batteries

To cold-swap batteries in your battery bay follow these

easy steps: (Figure 4-1)

1. Have a charged battery ready to install.

2. Shut down your notebook and disconnect the AC

adapter.

3. Unlock the battery by pushing the two release

latches toward the battery pack (Figure 4-1).

4. While pressing the release latches, lift the battery out

of the bay.

5. Insert a new battery into the bay, and press it down

so that the latches click into place.

6. Plug in the AC adapter and turn the power on.

Hot-swapping Batteries

To hot-swap batteries in your battery bay follow these

easy steps: (Figure 4-1)

1. Plug an AC Adapter into the system and connect it

to a power outlet.

Figure 4-1. Removing a Battery

2. Follow steps 3 through 5 in “Cold Swapping

Batteries”.

Be sure to plug in an AC Adapter prior to

removing the battery. There is no bridge

battery present to support the system

while the battery is being replaced. If you

do not use an AC Adapter you will lose

any unsaved files.

If the Lithium ion battery connector is not

fully seated, you may not be able to use

your notebook or charge your battery.

Battery Bay

Battery Pack

Release Latch

Battery Bay

Release Latch

clio.book Page 34 Friday, June 2, 2006 10:37 AM

1 ... 43 44 45 ... 112

Comments to this Manuals

No comments

Fujitsu C1410 User Manual Page 44

Comments to this Manuals

Related products and manuals for Laptops Fujitsu C1410