Fujitsu C1410 User Manual download pdf (Page 64)

LifeBook C1400 Series Notebook - Section Five

Your notebook will not

work on battery alone.

(continued)

No batteries are installed. Install a charged battery.

The batteries are improperly

installed.

Verify that the batteries are properly connected

by re-installing them.

Your installed batteries

are faulty.

Verify the condition of the batteries using the

Status Indicator panel and replace or remove

any batteries that are shorted. (See Status Indicator

Panel on page 11 for more information)

The batteries seem to

discharge too quickly.

You are running an application

that uses a lot of power due to

frequent hard drive access or

DVD/CD-ROM access, use of

a modem or LAN PC card.

Use both the primary battery and an optional

second battery and/or use a power adapter for this

application when at all possible.

The power savings features

may be disabled.

Check the power management and/or setup utility

settings in the Power Savings menu and adjust

according to your operating needs.

The brightness is turned all

the way up.

Turn down the brightness adjustment. The higher

the brightness the more power your display uses.

The batteries are very old. Replace the batteries.

The batteries have been

exposed to high temperatures.

Replace the batteries.

The batteries are too hot

or too cold.

Restore the notebook to normal operating tempera-

ture. Charging icon on the Status Indicator panel

will flash when battery is outside of operating range.

Shutdown and Startup Problems

The Suspend/Resume

button does not work.

Suspend/Resume button is

disabled from the Power ->

Advanced submenu of the

setup utility.

Enable the button from the setup utility.

You did not hold the button

in long enough.

Hold the button longer. This may need to be a few

seconds if your application is preventing the CPU

from checking for button pushes.

There may be a conflict with

the application software.

Close all applications and try the button again.

The system powers up, and

displays power on informa-

tion, but fails to load the

operating system.

The boot sequence settings

of the setup utility are not

compatible with your

configuration.

Set the operating source by pressing the [ESC] key

while the Fujitsu logo is on screen or use the [F2]

key and enter the setup utility and adjust the source

settings from the Boot menu. (See BIOS Setup

Utility on page 27 for more information)

You have a secured system

requiring a password to load

your operating system.

Make sure you have the right password. Enter the

setup utility and verify the Security settings and

modify them as accordingly. (See BIOS Setup Utility

on page 27 for more information)

Internal hard drive was

not detected.

Use the BIOS setup utility or Primary Master

submenu, located within the Main menu, to try to

auto detect the internal hard drive.

Problem Possible Cause Possible Solutions

clio.book Page 54 Friday, June 2, 2006 10:37 AM

1 ... 63 64 65 ... 112

Comments to this Manuals

No comments

Fujitsu C1410 User Manual Page 64

Comments to this Manuals

Related products and manuals for Laptops Fujitsu C1410