Fujitsu C1410 User Manual download pdf (Page 63)

Troubleshooting

Power Failures

You turn on your

LifeBook notebook and

nothing seems to happen.

The installed primary battery

is completely discharged, there

is no modular bay battery

installed or there is no Power

adapter (AC or Auto/Airline)

installed.

Check the Status Indicator Panel to determine the

presence and condition of the batteries. (See Status

Indicator Panel on page 11 for more information)

Install a charged battery or a Power adapter.

The primary battery is

installed but is faulty.

Use the Status Indicator panel to verify the presence

and condition of the batteries. (See Status Indicator

Panel on page 11 for more information) If a battery is

indicating a short, remove that battery and operate

from another power source or replace that battery.

The battery or batteries are low. Check the Status Indicator Panel to determine the

presence and condition of the batteries. (See Status

Indicator Panel on page 11 for more information) Use

a Power adapter to operate until a battery is charged

or install a charged battery.

The power adapter (AC or

auto/airline) is not plugged

in properly.

Verify that your adapter is connected correctly. (See

Power Sources on page 25 for more information)

The Power adapter (AC or

auto/airline) has no power

from the AC outlet, airplane

seat jack, or car cigarette

lighter.

Move the AC cord to a different outlet, check for

a line switch or tripped circuit breaker for the AC

outlet. If you are using an auto/airline adapter in

a car make sure the ignition switch is in the On or

Accessories position.

The Power adapter (AC or

auto/airline) is faulty.

Try a different Power adapter or install a charged

optional second battery.

Your LifeBook notebook

turns off all by itself.

The power management

parameters are set for auto

timeouts which are too short

for your operating needs.

Press any button on the keyboard, or move the

mouse to restore operation. If that fails, push the

Power/Suspend/Resume button. Check your power

management settings, or close your applications and

go to the Power Savings menu of the setup utility to

adjust the timeout values to better suit your needs.

You are operating on battery

power only and have ignored a

low battery alarm until the

batteries are all at the dead

battery state and your machine

has gone into Dead Battery

Suspend mode.

Install a power adapter and then push the Power/

Suspend/Resume button. (See Power Sources on

page 25 for more information)

You have a battery failure. Verify the condition of the batteries using the

Status Indicator panel, and replace or remove

any batteries that are shorted. (See Status Indicator

Panel on page 11 for more information)

Your power adapter has failed

or lost its power source.

Make sure the adapter is plugged in and the outlet

has power.

Your notebook will not

work on battery alone.

The installed batteries are

dead.

Replace the battery with a charged one or install

a Power adapter.

Problem Possible Cause Possible Solutions

clio.book Page 53 Friday, June 2, 2006 10:37 AM

1 ... 62 63 64 ... 112

Comments to this Manuals

No comments

Fujitsu C1410 User Manual Page 63

Comments to this Manuals

Related products and manuals for Laptops Fujitsu C1410